[Rtk-users] Questions about xim / fdk

[Sharp, Gregory C.]

Hi all,  I have a few questions:

Is there any viewer for these files and/or can I convert them into mha?

Are the xim files already dark and flood corrected?

What are the units for the fdk output?  Can they be scaled into something like HU?

Is there a way to specify subsets of gantry angles to be used in the fdk recon?

Thank you,
Greg

The information in this e-mail is intended only for the person to whom it is addressed.  If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Mass General Brigham Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline <https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted).  If you do not wish to continue communication over unencrypted e-mail, please notify the sender of this message immediately.  Continuing to send or respond to e-mail after receiving this message means you understand and accept this risk and wish to continue to communicate over unencrypted e-mail.